Shanghai Dea Chemical Equipment Co., Ltd.
Shanghai Dea Chemical Equipment Co., Ltd. DEA Service For The World
Add to Cart
500W Power Thin Film Evaporator for CBD / THC / Hemp oil / Cannabissativa
—— Design
Wiped Film Evaporators are horizontal evaporator with wiper basket, gear motors and external condenser.
The vapour nozzle is typically arranged at the upper end of the evaporator in order to facilitate the transfer of the vapours to the external condenser.
Dea offers thin film evaporators from 0.058 to 3 m2 .
| TYPE | BML-50 |
| MATERIAL | stainless steel 304/S316L |
| TEMPERATURE | Room temp~ 200/300 ℃(depend on the Electric heater ) |
| DIAMETER | 200 (mm) |
| HEAT EXCHANGER HTA | 0.5(m2) |
| FEED AMOUNT | 20~60( l/h) |
| ROTATION SPEED | 40-250rpm |
| FILM SYSTEM | Wiped Filming System |
| VACUITY | 0.1mbar(depend on the nature of material and vacuum pump)(vacuum pump not included) |
| FLOOR AREA | length*width*height=1200*800*2500 (mm) |
| POWER | 500W (without pump) |
| VOLTAGE | 220V/60hz |
With Thin Film Evaporator , a substantial decrease of boiling temperature is obtained by reducing the operating pressure. This allows thermal separation of products that would be destroyed by conventional vacuum distillation (pot still or distillation column) because of the necessary high temperatures and long residence time.
In a Thin Film Evaporator the raw material is heated up on the internal surface of a heated tube until the lower boiling component starts to evaporate. These vapors are then liquefied on the cold tubes of a condenser. In simple thin film evaporator design the condenser is located outside but as close to the evaporator as possible.